1. Please make a distinction your two computers normally
(Start Menu / Config Panel / Network and Internet Connections / Bluetooth)
Just one computer needs to be additional; the other is accepted and added automatically.
2. This is done on both computers and the host first.
Go to Start Menu / Config Panel / Network Connections
Click on Create a home network or corporate network light and go after the prompts. After that you share your files and your printer but not your Internet connection.
3. On the host computer:
Go to Start / Run
Type CMD
Type ipconfig / all
Parallel to AC, go to:
Start Menu / Config Panel / Network Connections
Then right-click on Network Connection properties bluetooth then click on Internet Protocol (TCP / IP) and properties.
Check Use the following IP address and put the one IP address as in Ethernet card Bluetooth network connection.
In use the following DNS server addresses that are being shown under 'PPP Map Nine' That's for me but you ca depends on the standard used for your Internet connection, or look for servers there are marked DNS, there are 2, they are fine then add the above. You turn the whole and that's it for the host.
4. You do the equal in observe to the second computer except for that you must add a bridge to the right function. It is in the Advanced tab, where you have set the ip / dns. And gateway is the ip of the host computer. But for the IP address change the last two values that you want.
Keep in mind to check allow other network users to connect via the Internet from this computer in the properties of your Internet connection.
0 comments:
Post a Comment